EIGRP Redistribution of Different AS:
In this tutorial i will show you that how to communicate the two different AS(Autonomous System) in gns3. EIGRP Redistribution of Different AS are need to performed on edge router having different AS configure on it. For this i have create a lab in gns3, in our topology R3 is the router on which we shall perform redistribution. For IP and EIGRP configuration you can visit EIGRP configuration on GNS3. But you need to make some changes on R3, R5 and R6 i.e. run "router rigrp 200" instead of "router rigrp 100".
EIGRP Redistribution Commands:
R3(config)#config t
R3(config)#router eigrp 200
R3(config-router)#network 3.3.3.0 0.0.0.255
R3(config-router)#network 4.4.4.0 0.0.0.255
R3(config)#exit
R3(config)#router eigrp 100
R3(config-router)#network 2.2.2.0 0.0.0.255
R3(config)#router eigrp 100
R3(config-router)#redistribute eigrp 200
R3(config-router)#ex
R3(config)#router eigrp 200
R3(config-router)#redistribute eigrp 100
Verification:
R2#show ip route
You will find the other EIGRP AS routes with EX tag.
As we know that BGP is used between connection of different AS. So, where are BGP have been used as it is working fine, but i have't seen that where BGP have been used. Can any give some argument for this
ReplyDeleteCan any one tell me that here we have used the Redistribution Techniques for updating Routing tables of both AS. But we know that we just used BGP for that Purposer.so why we have't used BGP for that purposes
ReplyDeletethanks for this one
ReplyDeleteThanks for this simple command but helpful to connect Two AS.
ReplyDeleteThank you for helping me to connect two differents AS!!!
ReplyDeleteVery good!
ReplyDeleteVery good!
ReplyDeleteExcellent!!
ReplyDeletehelpful
ReplyDeleteHello Sir,
ReplyDeleteI had done the some configuration but it say eigrp to eigrp redristribution is not allowed